Xenon Racing GPR48-090 90T Precision Spur for Touring Cars  [GPR48-090]

Price:
NZD$12.17
Brand:
Xenon Racing
Model:
GPR48-090
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Accurate gearing from Xenon Racing GPR48-090

The Xenon Racing GPR48-090 90T Spur Gear brings 48-pitch accuracy to touring car drivetrains, helping reduce slop and deliver smoother torque transfer. It is aimed at drivers who tune setups for consistent lap times.

Optimised for 1/10 scale circuits

This 90-tooth spur is sized for 1/10 scale touring use, giving fine control over gear ratio choices without adding unnecessary mass. It suits racers looking to tweak acceleration and mid-range response for different track layouts.

Built to last and fit widely

Produced from sturdy materials, the spur withstands routine racing stresses and pairs with a wide array of touring car gearboxes, offering a dependable replacement or upgrade for workshop spares boxes.

Can I use this with my slipper clutch setup?

Yes, the GPR48-090 is compatible with standard slipper clutch arrangements that accept 48-pitch spurs, though you may need to recheck mesh and slipper preload when swapping gears.

Which pinion size pairs well with 90T for tight tracks?

For shorter, technical circuits try a smaller pinion to increase acceleration and control; the exact size depends on motor Kv and tyre diameter, so test increments to find the best ratio.

How do I check gear mesh correctly?

Fit the spur and pinion, add a piece of paper between teeth, rotate and tighten until slight friction appears, then remove paper and confirm minimal clearance across the mesh.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved