Xenon Racing GPR64-095 Precision 64 Pitch Spur Gear 95T  [GPR64-095]

Xenon Racing Xenon 64 Pitch PR Spur Gear for Touring Car, 95T GPR64-095
Price:
NZD$12.20
Brand:
Xenon Racing
Model:
GPR64-095
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Fine-Tune Your Touring Car Drivetrain

The Xenon Racing GPR64-095 is a 64 pitch spur gear made for RC touring cars, featuring 95 teeth for close-ratio adjustments. Constructed from durable material, it is intended to provide smooth engagement and steady performance during club runs or practice sessions.

Optimised Mesh and Efficiency

With its 64 pitch tooth profile the gear promotes precise meshing to reduce friction and drivetrain loss. The design aims to balance rigidity and lightness so handling stays responsive under load.

Simple Swap-In Compatibility

This spur gear is compatible with a broad selection of touring car gearboxes and can be used as a direct replacement or upgrade. Installation is straightforward for hobbyists familiar with basic gear spacing checks.

Is the bore size standard for popular touring car brands?

Bore sizes can vary by manufacturer; measure your existing spur or check your chassis manual to ensure the Xenon Racing GPR64-095 will fit without an adapter.

Can I use this gear for indoor carpet racing?

Yes, the 95-tooth option is useful for tuning gear ratios on carpet where precise steps help optimise acceleration and corner exit. Adjust meshing for quiet operation.

Will the 64 pitch help reduce drivetrain noise?

Properly set 64 pitch meshing can cut slop and vibration, which reduces noise levels compared with worn or mismatched gears.

Any tips for getting the mesh right?

Use feeler gauges or a paint transfer method to set a small amount of clearance, then run a few short tests and recheck the mesh after heat cycles.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved