Xenon Racing GPR64-110 High-Precision 64 Pitch Spur Gear  [GPR64-110]

Xenon Racing Xenon 64 Pitch PR Spur Gear for Touring Car, 110T GPR64-110
Price:
NZD$12.17
Brand:
Xenon Racing
Model:
GPR64-110
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Fine-Tune Gear Ratios with Xenon Racing GPR64-110

The Xenon Racing GPR64-110 offers a true 64 pitch design with 110 teeth for touring car setups that demand accurate ratios and predictable response. Its tooth geometry is optimised for consistent contact and controlled power flow.

Engineered Teeth Profile for Smooth Acceleration

Careful machining of each tooth reduces impact between pinion and spur, helping to smooth out acceleration and lowering the risk of sudden load spikes that can stress driveline parts.

Designed for 1/10 Touring Transmissions

Specifically aimed at 1/10 touring platforms, the GPR64-110 drops into standard gear trains and makes tuning gear ratios straightforward for track conditions or practice sessions.

Will this fit my 1/10 touring car gearbox?

If your car uses a 64 pitch spur and the same tooth count, the GPR64-110 should fit. Double check pinion spacing and mesh before final installation.

What effect does the 110 tooth count have on handling?

A higher tooth spur like 110 gives finer ratio steps and can smooth top-end delivery, which some drivers prefer for consistent corner exits.

How should I break in a new spur gear?

Run light, low-load laps at first to seat the teeth, then inspect mesh and rotate the gear to check for even wear before full-power use.

Any tips for choosing a pinion to match this spur?

Match a 64 pitch pinion and consider desired ratio and track layout. Smaller pinions give acceleration, bigger ones increase top speed.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved