Xenon Racing GPR-6-90 Heavy Duty 64P Spur Gear  [GPR-6-90]

Price:
NZD$12.17
Brand:
Xenon Racing
Model:
GPR-6-90
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

GPR-6-90 64P/90T Spur Gear for Accurate Power Transfer

The Xenon Racing 64P/90T spur gear, model GPR-6-90, has been produced to deliver steady, reliable gear engagement for RC models. Its 90-tooth profile helps maintain smooth power flow and is suitable for a variety of on-road and off-road chassis.

Features That Matter to RC Builders

Balance between toughness and precise tooth form makes this spur gear a strong choice when you want repeatable performance. The 64 pitch specification provides a robust interface with compatible pinions to reduce slop and extend component life.

Setup Notes for Long Service Life

Set the mesh carefully and recheck after a few runs to allow components to bed in. Cleaning out grit and checking for burrs will prevent accelerated wear, and matching pinion materials will help tune durability versus weight.

Which chassis commonly accept this GPR-6-90 spur gear?

Many 1/10 and similar scale RC kits that use 64 pitch gears will accept the Xenon Racing GPR-6-90, but you should confirm bolt spacing and clearance for your specific gearbox before fitting.

Is special lubrication required for this gear?

A light application of gear grease where the mesh runs is usually sufficient; avoid over greasing as that can attract dust and grit which accelerates wear.

Can this spur gear handle high torque motor setups?

It handles moderate to high torque when installed with compatible pinions and proper mesh, but very high torque systems may require hardened or upgraded pinions to match the spur.

Should I check runout after installing?

Yes, verify that the spur runs true with no wobble; runout can cause uneven tooth contact and premature wear.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved