Xenon Racing PPR64-30 64P/30T Race Pinion [PPR64-30]

Xenon Racing Xenon Pinion Gear 64P/30T PPR64-30

Price:

NZD$15.56

Brand:

Xenon Racing

Model:

PPR64-30

Not Available

Please kindly input your name and email address, we will inform you once we have the restocking.

Or you may find similar product under the

R/C General - Gears - Pinion Gears

High Precision 64P Pinion for RC Enthusiasts

The Xenon Racing PPR64-30 pinion combines a 64-pitch profile with 30 teeth to deliver consistent gear mesh for RC setups. Its geometry is targeted at reducing vibration and improving the feel through the drivetrain.

How This Pinion Helps Your Setup

Fitting the correct pinion affects both acceleration and top speed balance. The Xenon Racing PPR64-30 is produced to hold accurate tooth form so it mates cleanly with spur gears, helping limit premature wear on the gearbox.

Will this 64P pinion work with my current spur?

It will if your spur is 64-pitch and the tooth counts form an appropriate ratio. Check the pitch marking on the spur and compare tooth counts to confirm a compatible ratio.

What should I look for during installation?

Ensure axial alignment on the motor shaft, set a consistent backlash and secure the pinion grub screw or nut to avoid slippage under load.

Is any special care required after racing?

After sessions, remove debris, inspect teeth for damage and recheck mesh and fasteners to keep performance consistent.

Can I swap tooth counts to tune speed?

Yes, changing the pinion tooth count alters acceleration and top speed. Make small steps and test to find the best balance for your track and motor.

Hot Brands