Xenon Racing PPR64-31 Racing Grade 64P Pinion Gear  [PPR64-31]

Xenon Racing Xenon Pinion Gear 64P/31T PPR64-31
Price:
NZD$15.56
Brand:
Xenon Racing
Model:
PPR64-31
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Fine-Tuned 64P Pinion Performance

The Xenon Racing PPR64-31 pinion is targeted at hobbyists who want accurate gear engagement and dependable service. Its 64 pitch and 31 tooth count produce a precise mesh that helps when swapping ratios or refining drivetrain setup. It performs well whether you are on the podium or enjoying rough terrain runs.

Strong Construction for Heavy Use

Made from robust materials, this Xenon Racing pinion resists the common wear seen in demanding RC use. The design helps preserve tooth profile and maintain consistent gear contact, giving you confidence to experiment with gear ratios and tuning across different surfaces.

Can I pair this with a brushless motor?

Yes, the PPR64-31 works with brushless or brushed motors as long as the vehicle uses a 64-pitch geartrain and the pinion fits the motor shaft. Confirm shaft style and set-screw alignment.

Will changing to 31T affect top speed a lot?

Tooth count changes alter gear ratio and influence acceleration versus top speed. Use this 31T pinion as part of overall gearing changes and test on your setup to find the right balance.

Any tips for getting quiet gear mesh?

Start with a snug backlash and back off slightly until noise drops. Run a few slow rotations, check tooth contact pattern, then fine tune for silent engagement under load.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved