Xenon Racing PPR64-39 Race-Grade 64P/39T Pinion  [PPR64-39]

Xenon Racing Xenon Pinion Gear 64P/39T PPR64-39
Price:
NZD$15.56
Brand:
Xenon Racing
Model:
PPR64-39
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Tune Your Model with the Xenon Racing PPR64-39 Pinion

The Xenon Racing PPR64-39 pinion gear brings a 64-pitch, 39-tooth design to improve drivetrain behaviour in RC models. It helps deliver cleaner power transfer to the spur, making it a practical choice for those refining setup for track days or weekend builds. The pinion is useful as both an upgrade and a dependable replacement part.

Why Choose the 64P/39T Arrangement

This 64P/39T option gives precise tooth engagement that supports smoother running and less noise compared to coarser pitches. The tooth count gives a sensible balance between low-end drive and higher speed potential, which suits a wide range of on-road and light off-road models.

Installation Tips and Fit Guidance

Fitting is straightforward in many standard gearboxes, but always confirm clearance with your spur gear and motor mount. Make small mesh adjustments and test under load to ensure clean engagement and to avoid excessive wear during spirited running.

Can I use this pinion for dirt and grass bashing?

Yes, it is suitable for many mixed-surface uses, but check for grit ingress and secure the gearbox to reduce premature wear when running on rough terrain.

Will this pinion make my motor hotter?

Proper mesh and matching spur ratios keep heat in check; poor mesh will increase load and temperature, so set the gear engagement correctly after fitting.

How often should I inspect the pinion?

Give it a quick check after a few runs, looking for chipped teeth and looseness. More frequent checks are wise if you use the model off-road.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved