Xenon Racing PPR64-42 Track-Tuned 64P Pinion Gear  [PPR64-42]

Xenon Racing Xenon Pinion Gear 64P/42T PPR64-42
Price:
NZD$15.56
Brand:
Xenon Racing
Model:
PPR64-42
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

Track-Tuned 64P Pinion for Better Power Delivery

The Xenon Racing PPR64-42 pinion is built to give smoother power transfer and tighter gear engagement for competitive runs. Its 42-tooth 64P configuration suits drivers looking to refine acceleration and gear ratio experiments.

Accuracy That Holds Up Under Pressure

Produced with precise machining, the Xenon Racing pinion resists premature wear and maintains consistent tooth alignment lap after lap. This stability helps preserve spur gear life and drivetrain efficiency.

Quick Swap for Testing and Tuning

Designed for straightforward replacement, the Xenon Racing PPR64-42 makes trialling different ratios fast, helping you dial in performance without lengthy downtime.

Can I use this pinion with brushless setups?

Yes, the PPR64-42 is compatible with brushless motors as long as shaft diameter and bore match; check motor pinion specs before fitting.

Will the 64P pitch mesh with common spurs?

64P requires a matching 64P spur for optimum mesh. Mixing pitches can cause rapid wear and poor engagement, so match pitch across the drivetrain.

How do I check gear mesh after fitting?

Apply a thin smear of gear marking compound to the teeth, rotate the gears slowly and inspect contact pattern. Adjust backlash until contact is centered.

Is this pinion suitable for both on-road and light off-road use?

It performs best on paved surfaces and prepared tracks where fine pitch gears stay protected, though it can be used off-road if debris is managed and protection is in place.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved