XRAY 302582 Composite Servo Horn Retro Replacement for Futaba and Robe  [XR-302582]

XRAY 302582 Composite Servo Horn - Futaba / Robe
Price:
NZD$10.07
Brand:
XRAY
Model:
XR-302582
Condition:
Brand New
Write a review

Precision Replacement Part XRAY 302582 Composite Servo Horn

The XRAY 302582 composite servo horn is built to work with a range of Futaba and Robe servos and suits hobbyists repairing classic T Series kits. Its engineered profile aims to provide steady steering input without adding complexity.

Which Servos It Works With

This horn is matched to typical Futaba and Robe spline patterns so it sits flush on compatible servos and reduces unwanted play in the steering linkage. It is a sensible swap when worn servo horns cause vague steering.

Step by Step Fit Guide

Ensure the servo is unpowered, align the horn on the servo spline, press it fully home, and fasten with the correct screws. Use careful tightening to avoid stripping or stress on the horn material.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How hard is it to swap this horn?

Swapping is simple for most hobbyists: power off the servo, remove the old horn, fit the new one and secure the screws. No special tools are usually required beyond basic hex drivers.

Should I change other parts at the same time?

If the horn is worn, check the servo output shaft and linkages for wear as well. Replacing related hardware can restore crisp steering feel.

Can this horn handle high torque servos?

It is designed for standard hobby servos; verify your servo torque and monitor the horn after first runs if you use high power digital servos.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved