XRAY 302711 Front Brass Suspension Holder - Lower 1-Piece FF  [XR-302711]

XRAY 302711 Brass Front Lower 1-Piece Suspension Holder - Front - FF
Price:
NZD$76.75
Brand:
XRAY
Model:
XR-302711
Condition:
Brand New
Write a review
alt="XRAY 302711 Brass Front Lower 1-Piece Suspension Holder - Front - FF" title="XRAY 302711 Brass Front Lower 1-Piece Suspension Holder - Front - FF"
alt="XRAY 302711 Brass Front Lower 1-Piece Suspension Holder - Front - FF" title="XRAY 302711 Brass Front Lower 1-Piece Suspension Holder - Front - FF"

Front ballast solution from XRAY 302711

Track-focused builders will value the XRAY 302711 Brass Front Lower 1-Piece Suspension Holder for being purpose-built to sit on the front bulkhead and supply the extra mass needed to meet minimum weight targets while preserving chassis compliance.

Why pick brass over aluminium

Brass carries several times the mass of the aluminium version, creating a stronger low-down weight bias that helps stabilise the car side to side while keeping desirable chassis flex intact.

Change handling by where you fit it

Fitted at the nose it helps cut traction roll on high-grip circuits; fitted to the rear it loosens the car up, adding rotation and a sharper steering response on medium-grip layouts. It is an easy way to tailor behaviour to changing track grip.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is the XRAY 302711 suitable for all 1/10 touring setups?

It is intended for touring cars that accept a front lower suspension holder; compatibility depends on your chassis layout and existing parts, so compare mounting points first.

Will this affect tyre load and wear?

Adding mass forward shifts tyre load patterns slightly; monitor wear and consider small spring or camber tweaks if you notice changes after fitting.

Can I use it with different electronics layouts?

Yes, but check for space around the front bulkhead and battery location. You'll want to ensure cables and mounts do not interfere with the holder.

Any setup trick for high-grip tracks?

Use the brass at the front to reduce traction roll and pair it with slightly softer front springs to keep turn-in responsive on very grippy surfaces.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved