XRAY 303032 T2 Aluminium Quick Roll-Centre Holder 4.9mm Kit  [XR-303032]

XRAY 303032 T2 Aluminium minium Quick Roll-center Holder 4.9mm (2+2)
Price:
NZD$26.53
Brand:
XRAY
Model:
XR-303032
Condition:
Brand New
Write a review

Micro Tune Options for T2 Chassis

The XRAY 303032 T2 Aluminium Quick Roll-Centre Holder provides a simple way to refine roll-centre geometry on T2 cars. Precision edges allow quick swaps and small adjustments, helping you dial the car for corner entry and mid corner feel. The aluminium construction is chosen for a balance of toughness and lightness.

Responsive Handling for Club Tracks

At the 4.9mm setting the holder offers a predictable change in handling that suits drivers who tweak setup between heats. Its quick-change design reduces time spent on adjustments so you can react to grip changes. Aluminium strength helps the part resist deformation under load while keeping overall weight down.

Designed for T2 Fitment

Specifically produced to match the XRAY T2 series, this holder is ideal for hobbyists preserving or upgrading older T2 models. Fitting is straightforward and fits into routine workshop procedures without special tools.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use this with aftermarket suspension arms?

It is compatible where mounting geometry matches T2 standards; check arm dimensions and hole spacing before fitting aftermarket pieces.

Will it change ride height or only roll-centre?

The primary effect is roll-centre adjustment; small ride height differences can occur depending on your overall setup, so recheck camber and toe after fitting.

How long does installation usually take?

With basic tools expect a quick swap in the pits, typically under 10 minutes for a single side when following standard fitting steps.

Is any special hardware required?

The holder uses standard fasteners that usually come with the car or are common in RC toolkits; no exotic hardware is needed.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved