XRAY 303040 Retro T Series Rear Bulkhead Aluminum Brace  [XR-303040]

XRAY 303040 Aluminium minium Rear Bulkhead Brace
Price:
NZD$12.42
Brand:
XRAY
Model:
XR-303040
Condition:
Brand New
Write a review

Stiffen Your Retro T Series Rear End with XRAY 303040

The XRAY 303040 Aluminum Rear Bulkhead Brace is aimed at vintage T Series chassis, offering a straightforward upgrade to rear-end stiffness. Crafted from robust aluminium, it improves structural stability while keeping weight reasonable for classic setups.

Why Aluminium Works Well on the Rear Bulkhead

Aluminium adds rigidity where plastic can flex, reducing unwanted movement under load. The XRAY 303040 enhances rear-end consistency, helping to maintain predictable handling during competitive runs or club sessions.

Compatibility Focused on Older T Series Versions

This brace is tailored to fit older T Series layouts, so it usually installs without modification and is suitable for restorations and period-correct rebuilds.

Practical Fitment Tips for Best Performance

Align the brace carefully and tighten fasteners gradually to avoid misaligned holes. Recheck screw torque after a short break-in to secure the installation.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does this reinforce the rear for track use?

Yes, the brace increases rear structural stiffness which can help on high load corners, though final handling will depend on your overall setup.

Will the brace change my car's weight noticeably?

Any aluminium part adds some weight compared with plastic, but the change is small and is offset by improved rigidity for more consistent response.

How should I care for aluminium parts?

Keep surfaces clean and dry after wet runs. A light wipe and occasional inspection for thread wear will keep the brace in good condition.

Is additional hardware required to fit this brace?

Installation typically uses the existing rear bulkhead mounting points on older T Series cars. Verify your chassis screw sizes before starting the job.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved