XRAY 303098 T2(008) 3.5mm Graphite Rear Shock Tower - Precision Fit  [XR-303098]

XRAY 303098 T2(008) Shock Tower Rear 3.5mm Graphite - Ultra Strong
Price:
NZD$71.81
Brand:
XRAY
Model:
XR-303098
Condition:
Brand New
Write a review

Sturdy Graphite Rear Tower for Classic XRAY T Models

Designed to support older T series machines, this 3.5mm graphite rear shock tower brings a good balance of stiffness and control for the XRAY T2(008). The graphite construction helps the tower stand up to track impacts while keeping suspension geometry true. It is a dependable choice for those maintaining classic RC racers.

Graphite Benefits for Suspension Parts

Graphite offers low weight with solid strength, which keeps sprung mass down without sacrificing rigidity. The XRAY 303098 tower improves impact tolerance and reduces flex under load, helping to maintain consistent handling on a variety of surfaces. This makes it useful for preserving older chassis setups.

Quick Swap for Vintage Racing

The precise machining ensures a clean fit and simple installation into compatible T2 layouts. Whether prepping a car for club competition or restoring a favourite model, this shock tower helps retain correct shock geometry and steady performance during lap after lap running.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does this match original mounting points?

The tower matches T2(008) mounting positions. For other T series cars confirm hole spacing and shock eyelet location before fitting to avoid misalignment.

Will it change handling feel?

With its increased rigidity, the graphite tower can tighten rear end response and reduce flex-induced axle movement. Expect a slightly firmer rear feel, which can be tuned with spring and damper settings.

What installation tips should I follow?

Clean mounting surfaces, use correct length screws, and torque to suit graphite components. Check for clearance to other parts and recheck screw tightness after a few runs.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved