XRAY 303162 Extra-Hard Rear Suspension Arm - Race Tough  [XR-303162]

XRAY 303162 Rear Suspension Arm - Extra-Hard
Price:
NZD$18.35
Brand:
XRAY
Model:
XR-303162
Condition:
Brand New
Write a review

Stiffer rear arm for precision handling

The XRAY 303162 Extra-Hard Rear Suspension Arm is crafted for serious hobbyists chasing predictable rear-end behaviour. Made from a high-strength composite, this arm suits foam tyre running and sticky surfaces where reduced flex helps cornering consistency.

Optimised for foam tyre performance

This extra-hard version is intended to work well on tracks with high grip and with foam tyre compounds. The firm profile limits unwanted movement and keeps your suspension geometry stable. Each arm is marked XH so you can quickly tell left from right and mount it accordingly.

Wide compatibility for varied setups

Compatible with a selection of RC chassis, the XRAY 303162 offers a simple upgrade to increase rear stiffness without altering basic suspension layout. It is a practical choice for racers tuning for sharper response.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this arm suitable for carpet tracks with high grip?

Yes. The extra-hard composite is aimed at high-traction surfaces like carpet where a stiffer rear helps maintain consistent lines.

Will this change my car's handling too much?

It increases rear stiffness compared with standard arms, so expect crisper response and slightly reduced compliance. Test setups incrementally to find the right balance.

Can I use the same part on both sides of the car?

Yes. The XH marking is for identification only; the arm is interchangeable between left and right when installed correctly.

Are any special bushings or bearings required?

No special bushings are required beyond what your chassis normally uses. Standard hinge pins and hardware fit as intended.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved