XRAY 303730 T4'20 Aluminium Rear Lower Suspension Holder Front Set (2-Piece)  [XR-303730]

XRAY 303730 - T4\'20 Aluminium Rear Lower 2-piece Suspension Holder - Front (1)
Price:
NZD$30.84
Brand:
XRAY
Model:
XR-303730
Condition:
Brand New
Write a review

Rear Lower Holder Optimised for Asphalt Grip

The XRAY 303730 rear lower suspension holder is designed to sharpen handling for the XRAY T4'20 on asphalt tracks with low to medium grip. Crafted from Swiss 7075 T6 aluminium, the component offers consistent strength and tight tolerances.

Compatibility and Geometry

Built for standard rear suspension arrangements and compatible with Active Rear Suspension (ARS) systems, this holder provides additional roll centre positions. It is tailored to work with longer suspension arms to enhance stability and rear traction.

Setup Notes for Track Use

Focused on asphalt setups, the holder pairs effectively with the XRAY #303723 1-piece rear-rear (RR) aluminium suspension holder to balance rear traction and steering response under varying grip conditions.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How difficult is it to install the XRAY 303730?

Installation follows standard rear-suspension procedures; basic tools and careful alignment are needed for correct fitment on the XRAY T4'20.

What maintenance should I plan for this aluminium holder?

Check mounting hardware for tightness after sessions, inspect for wear at contact points, and clean debris to keep tolerances accurate.

Which suspension arms work best with this holder?

Longer rear arms are recommended to get the most from the holder and to improve rear stability and traction on asphalt layouts.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved