XRAY 305223 - 50mm ECS Drive Shaft for 2mm Pin - Handling Tune  [XR-305223]

XRAY 305223 ECS (ES) Drive Shaft 50mm for 2mm Pin - HUDY Spring Steel
Price:
NZD$54.29
Brand:
XRAY
Model:
XR-305223
Condition:
Brand New
Write a review

Tweak 1/10 scale handling with the XRAY 305223 ECS Drive Shaft

The XRAY 305223 ECS (ES) Drive Shaft is built for hobbyists who want tighter control from their 1/10 rigs. At 50mm and made from HUDY Spring Steel, it is engineered to steady the wheels and refine steering inputs without adding fuss.

Why HUDY Spring Steel Works Well

HUDY Spring Steel is known across the hobby for robust fatigue life and predictable behaviour. Using this steel in the drive shaft helps the whole drivetrain stay stable during repeated hard runs.

Practical Performance Gains

  • Reduced Vibration: Designed to cut unwanted wheel shake for cleaner lines.
  • Enhanced Steering: Faster, more accurate steering response when navigating tight corners.
  • Smoother Cornering: More consistent power transfer helps maintain speed through turns.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is the XRAY 305223 suitable for carpet and asphalt surfaces?

Yes, the shaft's vibration damping helps on both low and high grip surfaces, though final setup tweaks will depend on your chassis and tyres.

Will the 2mm pin size cause fitment issues?

Most 1/10 platforms use a 2mm pin system; check your hub and pin layout to confirm it matches the shaft specification.

Can I reuse existing hardware when upgrading?

Often you can reuse pins and set screws, but inspect them for wear and replace any components that show damage to ensure safe installation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved