XRAY 305590 Aluminium Middle One-way Pulley Set - Vintage T Series Gear  [XR-305590]

XRAY 305590 Aluminium minium Middle One-way Pulley Set
Price:
NZD$163.65
Brand:
XRAY
Model:
XR-305590
Condition:
Brand New
Write a review

Renew older T Series drivetrains with the XRAY 305590 aluminium part

Owners maintaining older XRAY T Series models will find the XRAY 305590 Aluminium Middle One-way Pulley Set useful as a direct replacement for aging components. The design aims to restore reliable operation to classic RC cars.

Why aluminium helps classic RC drivetrains

Aluminium pulleys typically resist deformation and cut down rotating mass compared to heavier stock pieces. That translates to steadier power delivery and reduced stress on adjacent drivetrain elements in older T Series setups.

Installation advice for consistent performance

Before installing the XRAY Aluminium Middle One-way Pulley Set, remove dirt and old grease from the area. Ensure the pulley sits square and spins freely, then recheck after a few runs to confirm there are no alignment issues.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is this part a direct swap for older assemblies?

In most cases this is a direct replacement for the original middle one-way pulley on earlier T Series cars, but verify mount points and shaft sizes before fitting.

Will aluminium change handling or feel?

The change is subtle; you may notice crisper drivetrain response and slightly less rotational inertia, which can help preserve throttle control on older models.

What should I check after first install?

After initial fitting, run a few short sessions and then inspect for play, secure fasteners, and heat marks. Re-torque any fasteners if needed.

Are there recommended lubricants to use?

Use light bearing oil or a thin synthetic grease where specified; avoid heavy pastes on rotating surfaces to keep drag low.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved