XRAY 332016 Aluminum Front Lower Bulkhead Right Swiss 7075 T6 Track Tuned  [XR-332016]

XRAY 332016 - Aluminium Lower Bulkhead Front - Swiss 7075 T6 - Right
Price:
NZD$81.07
Brand:
XRAY
Model:
XR-332016
Condition:
Brand New
Write a review

Lower Front Bulkhead Built for Stable Steering

The XRAY 332016 Aluminum Lower Front Bulkhead brings a stiff, dependable mounting point to the NT1.2 chassis. Swiss 7075 T6 construction provides strength where needed while still allowing controlled flex to keep front grip predictable on a variety of track surfaces.

Engineered Interaction with Bushings

The shape and tolerance of this bulkhead work smoothly with composite anti-roll bar bushings to minimise slop and extend service life. The result is a front end that stays consistent lap after lap, even when switching to harder rubber compounds.

Durable Finish and Exact Fit

The bright orange anodised coating defends against wear and gives a professional appearance. Chamfered edges and precision machining ensure the part seats cleanly for repeatable setup and easy replacement.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is the XRAY 332016 compatible with custom chassis parts?

It fits standard NT1.2 layouts; compatibility with custom or third party chassis depends on hole spacing. Measure your mounting points before swapping parts.

Will the anodise flake off under use?

The anodise is robust for normal racing use but may show wear in high contact areas; proper screw torque and avoiding metal-on-metal contact reduce abrasion.

Does this change spring or roll bar settings?

Not directly. It alters front stiffness, so you may fine tune spring or anti-roll bar settings to restore balance after fitting.

Can I use the same screws from the stock bulkhead?

In most cases yes, but check screw length and thread engagement. Replace any damaged fasteners and use medium strength thread locker where appropriate.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved