XRAY 333494 2.4mm Rear Anti-roll Bar for Ball-Bearings  [XR-333494]

XRAY 333494 - Anti-roll Bar For Ball-bearings - Rear 2.4 mm
Price:
NZD$23.84
Brand:
XRAY
Model:
XR-333494
Condition:
Brand New
Write a review
alt="XRAY 333494 - Anti-roll Bar For Ball-bearings - Rear 2.4 mm" title="XRAY 333494 - Anti-roll Bar For Ball-bearings - Rear 2.4 mm"

Refined Handling with XRAY 333494

The XRAY 333494 rear anti-roll bar brings a focused improvement to NT1 chassis behaviour by fixing roll at a 2.4mm diameter. It is aimed at drivers who want a cleaner balance between front and rear during circuit work.

Consistent Control Through Turns

This rear bar is built to pair with ball-bearings for smooth pivot action and dependable feedback. On tight and fast sections the XRAY bar helps the car stay composed while you push for faster lap times.

Straightforward Installation on NT1 Cars

Made for the XRAY NT1 series, the 2.4mm bar fits the standard mounting points and integrates without complex mods. It provides a practical stiffness increase that is easy to test during practice runs.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this bar fit all NT1 setups?

Yes, it is sized for NT1 mounting conventions and works with typical NT1 component layouts.

Is 2.4mm a common size for race tuning?

2.4mm is a popular choice for drivers wanting a noticeable but controllable increase in rear roll stiffness without making the car nervous.

Any maintenance tips after fitting?

Check the anti-roll bar mounts and bearing interfaces for play after a few runs, and re-tighten mounting hardware as required to keep response consistent.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved