XRAY 334024 - Multi-Flex Aluminium 2-Speed Mount for NT1.3  [XR-334024]

XRAY 334024 - Aluminium 2-speed Holder - Multi-flex - Black - Swiss 7075 T6 - Set
Price:
NZD$67.53
Brand:
XRAY
Model:
XR-334024
Condition:
Brand New
Write a review

Refine NT1.3 Balance with the XRAY 334024 2-Speed Mount

The XRAY 334024 Aluminium 2-Speed Holder is crafted to adjust NT1.3 chassis flex and rear-end feel, helping drivers dial in traction without adding excess mass. Its separate fitment from the rear bulkheads lets the rear section move more freely under load.

Additional Fixing Point for Tighter Rear End Control

An extra screw position reinforces the layshaft region, using three fasteners to reduce flex where the driveline meets the chassis. The result is crisper on-throttle stability for racing and club runs.

Vibration Damping and High-Strength Aluminium Construction

The bearing is located inside a composite bushing to lower engine-induced vibration, and the Swiss 7075 T6 aluminium construction offers a strong yet light support component, presented in a black finish.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use this on tuned pipe setups?

Yes, the vibration control design suits a range of engine layouts, but double-check mounting clearance and alignment when running high-rev engines.

Is the black finish durable for frequent track use?

The anodised black coating offers good scratch and corrosion resistance, though normal wear will show over time; keep screws checked after races.

Does the holder change weight distribution?

Its light alloy construction keeps added mass minimal, so handling changes come mainly from altered flex characteristics rather than significant weight shift.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved