XRAY 342045 Aluminium Front Upper Clamp Roll-Center Adjuster  [XR-342045]

XRAY 342045 Aluminum Front Upper Clamp with Adj. Roll-Center - Right
Price:
NZD$105.24
Brand:
XRAY
Model:
XR-342045
Condition:
Brand New
Write a review

Lightweight Aluminium Design for XRAY 342045

The XRAY 342045 Aluminium Front Upper Clamp provides a precision machined solution for drivers after lightweight strength. Crafted from Swiss 7075 T6 aluminium, the clamp reduces mass while keeping reliable rigidity. It clamps the front shock tower and the front upper arm mount to help preserve suspension geometry under race conditions.

Dial in Your Roll-Centre for Better Cornering

Changing roll-centre positions alters how the car transfers load through the suspension, letting you tune corner entry and mid corner balance. The clamp is well suited to racers who make frequent setup changes at the track.

Installation and Chassis Compatibility Notes

Designed to mate with new aluminium bulkheads, the XRAY 342045 is compatible with many chassis that share the same mounting pattern. Fit checks and correct torqueing are recommended to avoid misalignment and to ensure consistent handling.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How do I maintain the clamp for long life?

Keep mounting surfaces clean and check fastener torque after the first few runs. Inspect for impact damage and replace if threads or faces are deformed.

Does aluminium affect handling feel?

Aluminium increases stiffness compared to plastic parts, which can sharpen steering response and make roll-centre changes more noticeable.

Any fitment tips for older chassis?

Measure hole centers and thickness of your shock tower. Adapters or longer screws may be needed for non standard setups.

Is special hardware required?

Standard stainless steel screws typically work, but use the recommended lengths and thread types to avoid stripping the clamp or bulkhead.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved