XRAY 343044 Graphite Rear Upper Arm Holder 3.5mm Front - Race Tuned  [XR-343044]

XRAY 343044 - Graphite Rear Upper Arm Holder 3.5mm - Front
Price:
NZD$32.84
Brand:
XRAY
Model:
XR-343044
Condition:
Brand New
Write a review

Rear Arm Holder Designed for Tuned Handling

The XRAY 343044 Graphite Rear Upper Arm Holder improves rear suspension behaviour for drivers wanting more predictable balance. Built from 3.5mm graphite, it offers a resilient yet responsive mounting point for the upper arms.

Revised Bushing Positions for Cleaner Geometry

Updated eccentric bushing locations let you set the upper pins 2.5mm closer, making the holder compatible with narrower rear lower arm mounts. The front and rear mounting points on the rear upper clamps are arranged to maintain correct suspension alignment.

Built to Suit Narrow Rear Bulkheads

With a redesign focused on narrow bulkhead installation, the XRAY 343044 helps reduce unwanted rear stiffness and improves rotation through corners. This part supports riders looking to dial in smoother mid-corner behaviour.

Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
Check the spacing of your rear lower arm mounts and the bulkhead width. If your setup is narrower than standard, the XRAY 343044 is likely suitable, but physical measurement is recommended.
The reduced pin spacing increases lateral arm movement and can free up the rear suspension, improving grip on tighter circuits. Expect to rebalance toe and camber if needed.
After fitting, verify upper pin alignment, arm clearance through full travel, and recheck shock mounting angles. A test run with small setup tweaks will reveal the best position.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved