XRAY 343047 3.5mm Graphite Rear Upper Arm Holder - Narrow Bulkhead Edition  [XR-343047]

XRAY 343047 - Graphite Rear Upper Arm Holder 3.5mm - Rear
Price:
NZD$32.84
Brand:
XRAY
Model:
XR-343047
Condition:
Brand New
Write a review

Rear End Flex and Control

The XRAY 343047 Graphite Rear Upper Arm Holder is engineered to bring consistent rear suspension flex to racers and hobbyists. Built from 3.5mm graphite, it aims to stabilise rear traction while allowing useful compliance through cornering.

Adjusted Bushing Positions for Tighter Pin Spacing

Repositioned eccentric bushings enable the upper pins to be located 2.5mm closer, matching narrower rear lower arm mounts. This setup works with the fixed front and rear mount points on the rear upper clamps to keep the assembly secure during high loads.

Compatibility and Fast Fit

Best suited for chassis that use a reduced rear bulkhead width, the holder installs in place of the standard part and helps maintain correct suspension geometry for improved balance.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will this fit non XRAY brands?

It is primarily designed for XRAY-style rear bulkhead layouts; some third party cars with similar mounting patterns may fit but check measurements first.

Is the graphite treated or coated?

The part is raw graphite laminate at 3.5mm thickness, chosen for its balance of resilience and predictable flex.

Will the change in pin spacing affect camber?

Moving the upper pin positions alters instantaneous geometry slightly; check camber and toe after fitting and adjust as needed for your setup.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved