XRAY 343056 Swiss 7075 T6 Rear Suspension Arm Holder  [XR-343056]

XRAY #343056 - Aluminium minium Rear Lower Suspension Arm Holder - SwiSS 7075 T6
Price:
NZD$94.63
Brand:
XRAY
Model:
XR-343056
Condition:
Brand New
Write a review

Stiff, precise rear holder for vintage RX builds

Built from Swiss 7075 T6 aluminium, the XRAY 343056 rear lower suspension arm holder offers rigid support and accurate tolerances. CNC machining helps ensure consistent alignment and repeatable handling for older RX series models.

Material advantages for track and street

Swiss 7075 T6 aluminium gives a favourable balance of strength and weight, resisting distortion during hard cornering and repeated impacts so your suspension stays true longer.

Engineered for earlier RX chassis

This component is tailored to the dimensions of earlier RX series cars, fitting cleanly into original setups while improving robustness for both casual running and club competition.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use this on modern RX variants?

The part targets older RX series designs. For newer variants, compare the mounting pattern and part dimensions before fitting to avoid mismatches.

Will it change suspension feel?

Increased stiffness in the holder can make the rear-end feel more consistent under load, reducing flex-related handling quirks common in ageing plastic mounts.

Any special care after installation?

After fitting, run a few short sessions and recheck all screws and pivot points. Lubricate suspension pivots if needed and inspect for wear periodically.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved