XRAY 345648 48T Graphite 2-Speed Spur Gear - Lightened Edition  [XR-345648]

XRAY 345648 Graphite 2-Speed Gear 48T (1st)
Price:
NZD$39.01
Brand:
XRAY
Model:
XR-345648
Condition:
Brand New
Write a review
alt="XRAY 345648 Graphite 2-Speed Gear 48T (1st)" title="XRAY 345648 Graphite 2-Speed Gear 48T (1st)"

Upgrade Your Drivetrain with a Graphite Spur Gear

The XRAY 345648 Graphite 2-Speed Spur Gear 48T is crafted for serious model racers seeking better longevity and less rotating mass. Made from a specialised graphite blend, the gear delivers a mix of strength and controlled flex that helps reduce breakage and extend service life under race stresses.

Benefits of the Graphite Compound

Using graphite lowers the gear's weight which reduces inertia in the drivetrain and helps throttle response on stop-start tracks. The lighter gear can also ease loads on transmission bearings and contribute to overall drivetrain efficiency.

Accurate Form for Consistent Performance

Precision molding keeps each spur gear running true with minimal runout, which is essential for repeatable lap times. The tooth count is stamped on the gear for fast recognition when changing ratios between practice runs and finals.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

What chassis types will accept this 48T spur?

This 48T spur suits a range of chassis that specify a 48 tooth spur, commonly found in 1/10 electric buggies and touring cars with 2-speed gearboxes. Always confirm the mounting dimensions before fitting.

How does graphite compare to plastic or metal spurs?

Graphite offers a mid ground between nylon and metal, with lower mass than metal and greater toughness than standard plastic. That balance can improve acceleration while retaining resistance to repeat impacts.

Any setup tips when installing this gear?

Set gear mesh with a small clearance across the tooth face, secure the spur mounting hardware, and recheck mesh after a few heat cycles. Verify pinion size to match desired top speed and torque delivery.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved