XRAY 345800-O Graphite Pulley Covers - Orange  [XR-345800-O]

XRAY 345800-O Composite Belt Pulley Cover Set - Graphite
Price:
NZD$28.95
Brand:
XRAY
Model:
XR-345800-O
Condition:
Brand New
Write a review
alt="XRAY 345800-O Composite Belt Pulley Cover Set - Graphite" title="XRAY 345800-O Composite Belt Pulley Cover Set - Graphite"

Stiff Yet Light Pulley Guards

The XRAY 345800-O Composite Belt Pulley Cover Set is produced from graphite composite for a tough but lightweight shield that suits competitive and club-level RC models. The material choice helps maintain strength without adding unnecessary mass to the drivetrain.

Where These Covers Work Best

This set is compatible with a range of XRAY belt pulleys and helps keep belts clearer of dirt and small debris. The orange colouring aids quick visual identification when swapping parts or doing checks trackside.

  • #345820-O - Low Friction Composite 2-Speed Belt Pulley, 20T centre
  • #345838-O - Low Friction Composite Side Belt Pulley, 18T o8 rear
  • #345858-O - Low Friction Composite Front Belt Pulley, 18T o6 centre
  • #345888-O - Low Friction Composite Side Belt Pulley, 28T front
  • #345889-O - Low Friction Composite Side Belt Pulley, 29T front
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will these covers fit my current XRAY belt pulleys?

Check the pulley numbers and mounting holes against the items listed. If the numbers match the covers will fit the intended positions.

Do these covers change handling or performance?

You should not see a negative effect; the low weight of graphite composite keeps rotating mass low while protecting components, which helps consistent performance on different surfaces.

Any tips for installing the covers trackside?

Use the correct screws and avoid over-tightening. Inspect alignment before final torque to prevent belt contact with the cover edge.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved