XRAY 345888-G 28T Low Friction Graphite Pulley  [XR-345888-G]

XRAY 345888-G - LOW Friction Composite Side Belt Pulley 28T - Front - Graphite
Price:
NZD$21.60
Brand:
XRAY
Model:
XR-345888-G
Condition:
Brand New
Write a review

Precision Graphite Pulley Design

The XRAY 345888-G 28-tooth side belt pulley is engineered to refine drive performance on the RX8E 2023 series. Crafted from a graphite composite, it aims to cut rotating mass while keeping the strength needed for track abuse.

Why Graphite Works Well

Graphite composite brings a high stiffness to weight ratio and resists wear under frequent high speed runs. Installing the XRAY 345888-G part can help reduce belt drag and improve engine feel during acceleration.

Installation Notes

Mount this pulley on the outer side of the middle shaft where the side belt drives it. Note that the protective cover is sold separately as the #345800-G Composite Belt Pulley Cover Set for those wanting full enclosure.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use this on older RX models?

Compatibility depends on the shaft position and belt route of the older model. Check dimensions against the RX8E 2023 reference before fitting.

Does the pulley need a special belt type?

No special belt is required if you use the belt specified for the RX8E 2023 chassis. Keep correct tension and alignment for best results.

Will the pulley affect handling?

Indirectly. By reducing drivetrain friction and inertia, throttle response can improve which helps lap consistency, but chassis setup remains the primary handling factor.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved