XRAY 352318 Steel Front Suspension Holder - Laser Cut Upgrade  [XR-352318]

XRAY 352318 Steel Suspension Holder - Front - Laser Cut
Price:
NZD$17.23
Brand:
XRAY
Model:
XR-352318
Condition:
Brand New
Write a review

Laser-cut Steel Front Holder for Tight Tolerances

The XRAY 352318 Steel Suspension Holder is a zinc-coated part cut with laser accuracy for use in the front assembly of older XT Series RC models. The plate adds rigid support to the suspension mount and helps preserve handling by keeping components aligned.

Ideal for Older XT Series Chassis Repair

This replacement steel holder is designed to sit inside the composite suspension holder used on earlier XT Series cars. It takes stress off the original plastic parts, reducing cracking and stretch from repeated running. The laser-cut edges make installation straightforward and ensure consistent fitment across builds.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does this reinforce the stock composite holder?

Yes, it is intended to reinforce the composite holder on older XT Series vehicles and reduce the rate of wear under load.

Will the weight affect handling?

The steel adds a small amount of mass up front which can slightly alter balance, but most drivers notice improved durability without adverse handling changes.

How should I care for the zinc coating?

Keep the part free of grit and dry after wet runs; a light coating of oil on exposed fasteners helps protect the finish.

Can I use this in custom builds?

It can be adapted in many custom projects that share the same mount pattern, but confirm hole spacing before drilling or trimming.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved