XRAY 353116-XH Heavy Duty Hard Composite Rear Arm 6-degree  [XR-353116-XH]

XRAY 353116-XH - Composite Rear Lower Suspension Arm - 6 Degree -Hard
Price:
NZD$26.98
Brand:
XRAY
Model:
XR-353116-XH
Condition:
Brand New
Write a review

Stiffer Rear Suspension Arm from XRAY

The XRAY 353116-XH composite rear lower suspension arm targets drivers who push setups hard and need reliable parts. Built from a hard composite formula, this arm improves resistance to wear and impacts without adding unnecessary mass. Its 6-degree profile adjusts rear geometry to enhance rotation and mid-corner grip. Clearly stamped "XH" for quick recognition, this arm helps stabilise rear-end behaviour for more consistent lap times.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use the 353116-XH on rough surfaces like chip seal?

Yes, the hard composite material holds up better to abrasive surfaces than softer arms, but inspect adjacent parts like shocks and pivots for wear after rough running.

Will switching to this arm need suspension retune?

You may want to tweak toe and damping to balance the slightly different response. Small incremental changes and test laps will dial in the setup.

Does the XH version require special pins or hardware?

No special hardware is needed; the XRAY 353116-XH mounts with the same suspension pins and fasteners used by compatible XRAY rear assemblies.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved