XRAY 355433-XH GTX Series Front Central Dogbone 88mm Hudy Spring Steel  [XR-355433-XH]

Detailed view of the front central dogbone

This 88mm front central dogbone drive shaft is crafted from Hudy Spring Steel and hardened for improved wear life. Each piece is CNC-machined, finished by hand, and inspected to ensure consistent fit and acceptable runout for reliable operation.

Intended for front central use in GTX-compatible layouts, the shaft secures with HUDY hardened pins positioned at a 6° angle to preserve engagement under load. Lightweighting cuts unwanted mass while keeping essential strength, aiding in reduced rotational inertia at the front end.

When fitting, check the shaft length and mating dogbone interfaces against your vehicle parts to confirm compatibility, ensure pins are fully engaged, and replace any worn dogbones or bearings before service. As an upgrade, this shaft improves front-end responsiveness and helps maintain predictable drivetrain feel when combined with matched axles and bearings.

Built for hobby-grade model car drivetrains, this hardened, low-mass front central shaft offers a compromise of lower rotational weight and dependable longevity when properly installed and serviced.