XRAY 355632 116mm Rear Central Dogbone HUDY Steel Edition  [XR-355632]

XRAY 355632 - Rear Central Dogbone Drive Shaft 116mm - Hudy Spring Steel
Price:
NZD$64.85
Brand:
XRAY
Model:
XR-355632
Condition:
Brand New
Write a review

Precision Dogbone Built for Tough Terrain

The XRAY 355632 116mm rear central dogbone is manufactured from HUDY Spring Steel with CNC machining and a fine ground finish to provide dependable performance in rough off-road conditions.

Durability That Holds Up Under Stress

Hand-finishing ensures each shaft keeps tight tolerances so drivetrain movement stays smooth and predictable. This reduces slop and helps maintain consistent handling during aggressive runs.

Lightweight Careful Machining

Material is removed selectively to reduce rotating mass while retaining key load-bearing sections, giving better throttle response without sacrificing strength for everyday and competitive use.

Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.
If your kit specifies a 116mm rear central dogbone, the XRAY 355632 should be compatible. Confirm axle cup spacing and shaft ends to be sure of a direct fit.
You can apply light corrosion protection, but avoid removing critical material. Polishing is fine if done carefully to preserve geometry and balance.
No special bearings are required, but using high quality sealed bearings will reduce maintenance and help the XRAY 355632 run smoothly for longer.
Inspect after every hard session or every few races for wear marks or bends, and check mating components like cups and pins at the same time.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved