XRAY 365201 ECS 81mm Front Driveshaft Upgrade  [XR-365201]

XRAY 365201 - ECS Front Drive Shaft 81mm With 2.5mm Pin - Hudy Spring Steel - Set
Price:
NZD$112.61
Brand:
XRAY
Model:
XR-365201
Condition:
Brand New
Write a review
alt="XRAY 365201 - ECS Front Drive Shaft 81mm With 2.5mm Pin - Hudy Spring Steel - Set" title="XRAY 365201 - ECS Front Drive Shaft 81mm With 2.5mm Pin - Hudy Spring Steel - Set"

Performance Front Driveshaft for XRAY XB4 2019

The XRAY 365201 ECS Front Drive Shaft is engineered specifically for the XB4 2019 chassis. With an 81mm length and 2.5mm pin, its geometry preserves rotational harmony between wheel and shaft, and the Hudy Spring Steel build delivers long service life.

Joint Geometry That Cuts Binding

The ECS two-piece joint redistributes steep steering angles into two smaller pivots, which lowers binding and lets the front wheel articulate more freely. This reduces steering feedback and unwanted vibration when pushing hard through corners or landing jumps.

Consistent Control and Responsiveness

Upgrading to these shafts sharpens steering response and stabilises the front end for more predictable handling. Racers will find improved control under load, helping to maintain cleaner lines and repeatable lap performance.

Specifications

  • Length: 81mm
  • Pin Diameter: 2.5mm
  • Material: Hudy Spring Steel
  • Compatibility: XB4 2019 Series
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will XRAY 365201 fit older XB4 variants?

This part is made for the XB4 2019 layout. Older or revised XB4 versions may have different dimensions, so check your chassis specifications before fitting.

What upgrades pair well with these shafts?

Complement the shafts with hardened pins, quality bearings, and revised steering linkages to reduce slop and get the most from the ECS geometry.

Are special tools needed to install them?

Basic RC tools like hex drivers and a pin press or pliers are usually sufficient. Follow standard fitting steps and verify pin retention after first runs.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved