XRAY 365434 47mm Off-Road Central Dogbone Shaft HUDY Steel  [XR-365434]

XRAY 365434 - Central Dogbone Drive Shaft 47mm - Hudy Spring Steel
Price:
NZD$43.57
Brand:
XRAY
Model:
XR-365434
Condition:
Brand New
Write a review

High-Strength 47mm Dogbone for XB4 Setups

Committed racers and club drivers will find the XRAY 365434 Central Dogbone Drive Shaft a dependable choice. Forged from HUDY Spring Steel, the 47mm length resists fatigue better than many CVD alternatives, helping to lower service needs. It is intended for the XB4 series and suits both carpet and loose-surface race conditions.

Specifications

  • Material: HUDY Spring Steel
  • Length: 47mm
  • Compatibility: XB4 2021 Carpet/Dirt Specs

An effective upgrade for those who want a tougher driveline component that holds up under regular track use.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does this replace standard CVD dogbones?

It is an alternative to traditional CVD-type shafts and is chosen where increased wear resistance is required, provided the shaft dimensions match the vehicle spec.

Is the 47mm length critical for fitment?

Yes, length affects driveline geometry. Confirm the 47mm measurement against your XB4 setup before fitting to ensure correct operation and avoid binding.

How often should I inspect the shaft?

Check the dogbone after impacts and every few race meetings. Look for wear at the ends and any twisting or deformation that could signal replacement.

Any setup changes needed when upgrading?

Generally no major setup changes are required, but verify clearance and driveline alignment after installation to maintain smooth operation.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved