XRAY 372915 X10 Rear Aluminium Bulkhead - Race Ready  [XR-372915]

XRAY 372915 X10 Aluminium Rear Bulkhead FOR 1-PIECE Chassis - Motor - Right
Price:
NZD$83.31
Brand:
XRAY
Model:
XR-372915
Condition:
Brand New
Write a review

Rear Aluminium Bulkhead Designed for XRAY X10

The XRAY 372915 X10 Rear Aluminium Bulkhead is made to fit the XRAY X10 series 1-piece chassis and delivers improved rear-end strength. By keeping the motor mount stable under load, this part helps reduce drivetrain flex during hard acceleration and corner exits.

Durability without Excess Weight

Manufactured from robust aluminium, the XRAY 372915 bulkhead offers a favourable strength to weight ratio. It adds structure to the rear assembly while keeping mass low, which helps with mid corner balance and traction.

Straightforward Fit for X10 Chassis

Built specifically for the 1-piece X10 chassis, the XRAY 372915 fits cleanly with existing mounting points. The changeover is simple and lets you get back on track quickly with minimal setup tweaks required.

Specifications

  • Material: Aluminium
  • Compatibility: XRAY X10 Series 1-Piece Chassis
  • Position: Rear, Right Side

For racers who want a robust rear support without sacrificing handling, the XRAY 372915 X10 Rear Aluminium Bulkhead is a reliable upgrade for club and national level competition.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Is the XRAY 372915 compatible with earlier X10 variants?

This bulkhead is intended for the X10 series 1-piece chassis; check your chassis layout to confirm compatibility before ordering.

Can I run this with standard electronics?

Yes, the bulkhead is a mechanical part and works with typical motor mounts and electronics used on X10 cars. Verify motor spacing after install.

Does it require any modification to fit?

No major modifications are expected; standard screw locations and mounting hardware are used so the part is a direct replacement for compatible X10 1-piece chassis layouts.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved