XRAY M18T Steering Saver Bracket M18T-01/BU by 3Racing  [M18T-01/BU]

Protective steering bracket for the M18T

This aluminium steering saver bracket is engineered for the XRAY M18T platform and sold as model M18T-01/BU. It fits around the steering link area to absorb hits and reduce the load passed to the servo and nearby components.

The aluminium construction gives a tougher interface than many OEM plastics, helping keep steering geometry stable under repeated impacts. That reduced flex helps maintain toe settings and steering response between runs on rough surfaces.

Installation follows the XRAY M18T steering layout and attaches at the usual steering assembly points, working with the stock linkages and fasteners. No specialist tools are necessary beyond typical hex drivers used for model upkeep. After fitting, confirm linkage alignment and fastener tightness to ensure free travel and correct geometry.

Use the saver as part of a setup check focused on steering precision: recalibrate servo centring, check linkage lengths and tweak caster or ackerman as required. Expect gains in durability and consistency rather than a change in overall handling balance.