XRAY NT1 Aluminium 18T Pulley - XN1-40 by 3Racing  [XN1-40]

Team XRAY NT1 Aluminum Pulley 18T - 3RACING XN1-40
Price:
NZD$0.00
Brand:
3Racing
Model:
XN1-40
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
category
Write a review

18T aluminium pulley made for NT1

This 18-tooth aluminium pulley is supplied for use with the XRAY NT1 chassis as a direct replacement or spare for the belt drive system. It is aimed at routine drivetrain maintenance and setup checks where a durable, machined pulley is required.

Installation on NT1-spec cars is direct: take off the worn pulley, fit the replacement using the original spacers and fasteners, then confirm belt line and tension before running. No modifications to the chassis are necessary when used on compatible NT1 parts.

From a setup perspective, this pulley is a maintenance item that helps retain consistent belt routing and rotational behaviour. Drivers often swap to an identical aluminium pulley to recover handling consistency after service without changing pinion or gear choices.

Is the pulley compatible with NT1 upgrades?

It fits standard NT1 belt assemblies. If you have aftermarket upgrade parts, check spacer stack and belt path clearance before installation.

Any special maintenance needed?

Keep the pulley and belt free of grit and inspect for wear. Light cleaning and checking fastener torque after a few runs is usually sufficient.

Will switching to aluminium change handling?

As a like-for-like aluminium spare, it maintains existing behaviour and helps keep setup repeatable rather than altering core handling characteristics.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved