XRAY NT1 Turnbuckle Upgrade Titanium Finish XN1-39 by 3Racing  [XN1-39]

Turnbuckle upgrade for NT1 chassis

This set fits the XRAY NT1 chassis as a suspension and steering linkage accessory with a titanium finish. It replaces standard steel or aluminium turnbuckles where compatible, but you should verify fitment with existing ball ends and rod ends prior to installation.

Tuning role: turnbuckles are used to set toe and camber link lengths and can influence roll behaviour on touring car builds. Upgrading to titanium-finish links gives reliable threaded adjustments that stay put between runs.

Fitting advice: confirm left and right thread orientations for the NT1 and use the hex key size matched to your hardware. Hand-tighten to avoid damage, then check full steering and suspension range. When swapping matched-length components, adjust gradually while measuring alignment at both axles.

Maintenance: titanium-finish parts resist rust better than plain steel, but inspect threads occasionally and apply thread-locker only where you need permanent fastening. Keep linkage ball ends clean to prevent premature wear.