XRAY NT1 Wheel and Drive Bearing Pack BS-XN1/V1 by 3Racing  [BS-XN1/V1]

Team XRAY NT1 Ball Bearing Set - 3RACING BS-XN1/V1
Price:
NZD$36.34
Brand:
3Racing
Model:
BS-XN1/V1
Condition:
Brand New
Write a review

Bearing kit for NT1 touring cars

This ball bearing set is specified for use with the Team XRAY NT1 chassis and carries model BS-XN1/V1. It is designed as a scale replacement to fit the NT1 drivetrain and wheel mount positions.

The kit reduces rotational drag at axles and hubs while helping maintain shaft alignment under typical track and club conditions. Before replacing bearings on the NT1, check bore dimensions, clean mating surfaces, and inspect related components for signs of wear.

Fitting advice: press bearings straight and evenly into hubs and carriers, do not force at an angle, and verify differential and wheel hex clearance after installation. For maintenance, keep bearings free of dirt, inspect the races regularly, and replace any unit that develops play or rough rotation.

Specifications

  • Item Ball bearing set for Team XRAY NT1 chassis
  • Material Not specified by manufacturer
  • Model Number BS-XN1/V1
  • Compatibility Team XRAY NT1

A practical replacement option for NT1 owners needing to service drivetrain or wheel bearings, enabling clean swaps when tolerances degrade.

Are these bearings pre-greased or dry?

Product condition can vary; inspect the bearings on receipt and apply light lube if your setup benefits from it, but many racers fit them dry then use minimal oil if needed.

Will standard NT1 hop-ups affect fitment?

Most NT1 hop-ups that keep original bearing bores will be compatible, but check that upgraded carriers or hexes do not alter seat depths or bore diameters.

How often should bearings be replaced on track cars?

Replacement frequency depends on conditions; inspect after each wet or dirty event and consider swapping when you detect roughness or measurable play.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved