XRAY RX8 Front ONE-WAY Outdrive Adapter for Tuning - Arrowmax AM-RX8-345070  [AM-RX8-345070]

Arrowmax AM-RX8-345070 Front ONE-WAY Axle Outdrive Adapter (spring steel)
Price:
NZD$28.27
Brand:
Arrowmax
Model:
AM-RX8-345070
Condition:
Brand New
Write a review

Front ONE-WAY Outdrive Adapter Designed for XRAY RX8

The Arrowmax AM-RX8-345070 front ONE-WAY axle outdrive adapter is produced as a replacement part for the XRAY RX8 chassis. It is machined from spring steel and hardened to provide durable one-way performance as a replacement for the stock cup joint.

Fit this adapter when replacing a worn front ONE-WAY outdrive or when fine-tuning steering and weight transfer through drivetrain setup. The hardened finish focuses on resisting wear under common 1/10 on-road loads while preserving the intended engagement characteristics.

For installation: remove the original outdrive, inspect bearings and mating surfaces, insert the Arrowmax adapter into the outdrive housing, and confirm the one-way mechanism engages correctly before finishing reassembly. Also confirm axle fit and that C-clips and geometry settings are unchanged.

Specifications

  • Item: Front ONE-WAY Axle Outdrive Adapter
  • Material: Spring steel
  • Model Number: AM-RX8-345070
  • Compatibility: XRAY RX8

Used as a replacement component, this Arrowmax adapter suits XRAY RX8 touring cars where a hardened spring steel cup joint is preferred for reliable front one-way driveline function.

Does this require any machining or trimming?

No machining is expected; the adapter is intended as a direct swap. Still, check contact faces and clearances on your RX8 before final assembly.

Is the hardening process visible or tested?

The adapter is heat treated to improve wear resistance. This treatment is intended to keep the part stable under repeated drivetrain loads without altering geometry.

Should I change bearings when fitting this part?

It is good practice to inspect and replace worn bearings during the install so the one-way adapter runs against clean, properly seated components.

Will this affect steering feel on the track?

As a direct replacement it should maintain the RX8s intended one-way behaviour, helping keep predictable steering and weight transfer while you tune other setup parameters.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved