XRAY T4 53mm BB DJC Linkage Block by Arrowmax AM-010071  [AM-010071]

53mm BB DJC bearing block made for XRAY T4

The Arrowmax AM-010071 BB DJC is a 53mm bearing block produced to work with XRAY T4 linkage arrangements. It is an aftermarket component intended to match 53mm ball layouts and replace a compatible ball joint block where needed.

This block is a setup item that locates ball ends, preserves correct spacing between links, and can have measurable effects on steering geometry and roll-center when used during tuning. Always confirm your chassis link dimension is 53mm prior to installation to avoid misfit.

Installation follows normal T4 linkage procedures: remove the existing block, move any studs or bearings required, and secure fasteners to your normal torque. No specialist tools are required beyond common hex drivers used for XRAY T4 work. After fitting, check the full range of steering movement and recheck geometry measurements.

Use this BB DJC block when you need 53mm linkage geometry on XRAY T4 cars; treat it as a precise replacement part and confirm clearances after installation.