XRAY T4-20 Front Shock Tower Graphite Upgrade - Factory Pro O-XCP001  [FP-O-XCP001]

Price:
NZD$15.08
Brand:
Factory Pro
Model:
FP-O-XCP001
Condition:
Brand New
Write a review

Replacement front shock tower for T4-20 chassis

This part is a graphite front shock tower made for the XRAY T4-20 chassis and listed as Factory Pro O-XCP001. Its role is to locate front shock absorbers and allow different mounting positions to influence suspension geometry and shock behaviour.

Intended strictly for model car suspension tuning and service. Changing to this tower modifies shock attachment points and can affect roll centre and leverage ratios, so test any changes on the track. The graphite material provides a common balance of stiffness and lightness used in 1:10 touring setups.

For installation: remove the original tower per your chassis instructions, fit the replacement using the same alignment references, and reuse original mounting hardware where it is in good condition. Confirm clearance around the servo and linkages, line up shock shafts before final tightening, then run incremental setup checks.

Is Factory Pro O-XCP001 suitable for track use

Yes, it is a replacement tower intended for competition-style tuning, but verify your chassis version and test setup changes progressively to match track conditions.

Should I replace mounting hardware when fitting

You can usually reuse existing screws if they are in good condition; however, replace any stripped or corroded fasteners and use appropriate threadlocker on metal-to-metal joints.

Will this tower change shock travel limits

Mounting position changes can subtly affect shock angle and travel; check end stops and test the car to ensure suspension travel remains within safe limits.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved