Xray X4 Front Deck Braces 1mm / 2mm for Tuning by Factory Pro O-XCP013  [FP-O-XCP013]

Price:
NZD$16.76
Brand:
Factory Pro
Model:
FP-O-XCP013
Condition:
Brand New
Write a review

Front deck brace solution for Xray X4

The Factory Pro O-XCP013 brace pack provides a simple reinforcement option for the Xray X4 front upper deck. Two thickness choices let racers alter front stiffness in measured steps so you can dial in handling without altering the main chassis plate.

The set contains one 1mm brace and one 2mm brace, each supplied as a single piece to allow quick test swaps during setup. Thinner material preserves more front flex while the thicker plate raises front-end rigidity. Braces are produced to align with the X4 front upper deck mounting pattern so they can be fitted or stacked with the existing layout.

Installation tip: fit the braces using the stock front upper deck locations and original hardware where possible. Confirm hole alignment and part clearance before final tightening, and test changes on your usual surface to assess balance and steering changes.

What does the O-XCP013 kit include?

The kit includes one 1mm brace and one 2mm brace, each a single piece, intended for front upper deck tuning on the Xray X4.

Is drilling or trimming required to fit these braces?

Drilling or trimming is not normally necessary since the braces are cut to suit the X4 front upper deck mounting points. Check fitment before applying final torque.

What handling change should I expect between 1mm and 2mm?

Using the 2mm brace increases front stiffness and often yields a crisper steering response; the 1mm option keeps the front looser for smoother turn-in.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved