XRAY X4F'25 Graphite Rear Plate 2.0 for Touring - Factory Pro O-XCP023  [FP-O-XCP023]

Price:
NZD$23.14
Brand:
Factory Pro
Model:
FP-O-XCP023
Condition:
Brand New
Write a review

Graphite rear plate for the XRAY X4F'25

The Factory Pro O-XCP023 rear upper deck is an RC-grade graphite 2.0 plate built for the XRAY X4F'25 chassis. It replaces the stock rear deck to influence chassis rear stiffness and overall balance while remaining an aftermarket tuning part.

Fitted as a setup option, the graphite 2.0 plate changes rear behaviour during weight transfer and cornering, commonly used to reduce rear flex and help maintain traction on medium to high grip asphalt. Ensure the plate lines up with existing bulkheads and screw holes and check suspension and drivetrain clearance before final tightening.

Fitment advice: remove the OEM deck and either reuse or upgrade the fasteners, inspect screw lengths to avoid interference with moving parts, and torque screws evenly to protect chassis flatness. After installing, recheck wheel toe and droop so the car runs free without binding.

Can I use this on earlier X4 generations?

The part is made for the XRAY X4F'25. If you have an earlier X4, measure hole spacing and bulkhead positions to check whether the O-XCP023 will align correctly.

How will mid-corner behaviour change?

Expect reduced rear compliance and a firmer back end, which tends to stabilise mid-corner balance and makes traction more predictable on grippy surfaces.

What should I check after installation?

Verify that the deck clears driveshafts and suspension links, confirm screw lengths, and run through toe and droop checks before a full test session.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved