XRAY X4/T4 Graphite 2.5mm Upper Bumper Plate Upgrade - Factory Pro O-XCP017  [FP-O-XCP017]

Price:
NZD$17.76
Brand:
Factory Pro
Model:
FP-O-XCP017
Condition:
Brand New
Write a review

Front Bumper Upper Plate Details

This Factory Pro item, model O-XCP017, is an upper bumper plate sized and machined for the XRAY X4 and T4 range. Its 2.5mm graphite construction and X4/T4 bolt pattern make it a direct swap or an upgrade for the factory front bumper top plate.

Compatibility is limited to the stated XRAY X4/T4 series, so double-check your chassis before installation. The plate functions as the top section of the bumper assembly on touring and other on-road builds using the correct mounting layout.

For tuning, this upper plate offers a consistent graphite surface that crews and hobbyists use to tune front stiffness and tracking. It is handy when making small setup changes aimed at steering precision and serviceability during practice sessions or race meetings.

Care instructions are straightforward: keep contact faces free of grit, examine screw bosses after impacts, and fit replacements if any structural compromise appears. Use standard hobby tools and avoid overtightening fasteners.

Is O-XCP017 a direct replacement for the stock plate?

Yes, when your car is an XRAY X4 or T4 series and the factory plate uses the same 2.5mm graphite profile, this part will swap in using the existing mounting points.

What upkeep does graphite need?

Keep the graphite clean and free from oily residue. After impacts, check bolt holes and edges for delamination or cracking and replace the plate if any damage is found.

Will this change handling compared to plastic plates?

Graphite tends to be stiffer than many plastics, so you may notice a slightly sharper front response. Use it as part of a considered setup change alongside other front-end adjustments.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved