XRAY 355635 Rear Central Dogbone 111mm HUDY Spring Steel  [XR-355635]

XRAY XR-355635 Rear Central Dogbone Drive Shaft 111mm - Hudy Spring STEEL
Price:
NZD$67.53
Brand:
XRAY
Model:
XR-355635
Condition:
Brand New
Write a review

Race-Ready Central Dogbone for XRAY X12

The XRAY 355635 Rear Central Dogbone Drive Shaft is crafted for X12 cars, using HUDY Spring Steel at a 111mm length to deliver a balance of rigidity and controlled flex under load.

Construction and Finishing

CNC machining removes excess weight while keeping strength where it counts. Each shaft is hand-ground and individually checked to ensure tight tolerances and consistent dimensions for precise assembly.

Designed for Demanding Conditions

Targeted at off-road racing scenarios, this shaft withstands repeated impacts and high torque. Its compatibility with the XRAY X12 series makes it a dependable upgrade for competition setups.

Specifications

  • Construction: HUDY Spring Steel
  • Size: 111mm
  • Fitment: XRAY X12 Series

Perfect for builders and racers who want a rugged, well-machined replacement for X12 drive trains while keeping precise alignment and handling.
Remark :
Due to limited stock availability, please notice that some XRAY items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use this dogbone on older X12 variants?

It is intended for the X12 series; check your chassis dimensions and axle geometry if fitting to earlier variants as some adjustments may be required.

What benefits does HUDY Spring Steel provide?

HUDY Spring Steel offers high fatigue resistance and toughness, reducing the chance of sudden failure during rough off-road runs.

How do I check for wear on this shaft?

Inspect the ends for rounding, check the straightness on a flat surface, and ensure the mating cups rotate smoothly without play.

Are any special tools needed for installation?

Standard RC setup tools suffice; a small set of hex drivers and a truer or calipers for verification are useful to confirm correct placement and length.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved