XRT 8S Chassis Protection Plate Kit for TRAXXSP XRTZSP1A XRTZSP1 by GPM  [XRTZSP1A]

Underside protection for the TRAXXAS XRT 8S

Designed by GPM for the TRAXXAS XRT 8S, this plate set reinforces the front, centre and rear underside of the chassis. Each panel is manufactured from 304 stainless steel to resist corrosion and surface abrasion where the original chassis sees regular contact with terrain.

Panels are hand polished and inspected during production to ensure accurate, flat mating faces for a close fit to the stock chassis rails. Installation is non invasive and intended to use the vehicle's original mounting points, with the supplied fasteners used to secure each plate. The kit is supplied for direct attachment to the stock chassis using the recommended screws.

In practical use these plates protect critical underside areas during trail work and off road running, reduce edge wear from impacts, and help the chassis keep its flatness under repeated loads. They do not change suspension geometry or drivetrain alignment and are solely a protective structural upgrade for the scale model.

Install to protect and stiffen the XRT 8S chassis without altering the stock layout, and verify fastener torque after initial trail sessions.