Yokomo B10-008RGA Graphite Rear Suspension Arm for BD10  [B10-008RGA]

Yokomo B10-008RGA Graphite molded rear lower suspension arm (57mm-Shock42mm) for BD10
Price:
NZD$23.03
Brand:
Yokomo
Model:
B10-008RGA
GTIN:
0639342202379
Condition:
Brand New
Write a review

High Rigidity Graphite Arm for BD10

The Yokomo B10-008RGA rear lower arm is engineered for the BD10 platform and built from durable graphite to raise chassis stiffness. Its increased rigidity helps the car respond more directly to driver inputs while preserving the intended rear geometry. Key mounting dimensions remain 57mm between suspension pins and 42mm from the inner suspension pin to the shock pivot for reliable setup replication.

Compatible Models

  • MRTC-BD10
  • MRTC-BD10A
  • MRTC-BD10FF
  • MRTC-BD10LC
  • MRTC-BD10LCA
  • MRTC-BD10LCR
  • MRTC-BD10LCRA
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Does graphite change wear characteristics?

Graphite is tougher than typical plastic arms so it resists deformation and wear, though you should still inspect pivot areas for play over time.

Is extra hardware needed to install this arm?

No special parts are required for stock BD10 setups; use your existing pins and check that mounting holes line up with the 57mm and 42mm spacing.

Who benefits most from this upgrade?

Competitive drivers and those chasing crisper response on asphalt will notice the biggest gains from the stiffer graphite arm.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved