Yokomo B10-018A Graphite Rear Shock Tower BD10 Precision Part  [B10-018A]

Yokomo B10-018A Graphite rear shock tower for BD10
Price:
NZD$35.10
Brand:
Yokomo
Model:
B10-018A
GTIN:
0639342202430
Condition:
Brand New
Write a review

Sharper Handling for BD10 Chassis

Drivers looking to tighten corner entry and improve rear traction will find the Yokomo B10-018A Graphite Rear Shock Tower a reliable upgrade for BD10 cars. The graphite construction gives a stiffer mounting point while keeping weight low for better balance.

Models Covered and Installation

Designed for the Yokomo BD10 range, this tower fits MRTC-BD10, MRTC-BD10A, and MRTC-BD10FF variants. The part aligns with OEM holes to make fitting simple and to preserve stock shock geometry.

Benefits of a Graphite Tower

Graphite combines stiffness with lightness, reducing unwanted chassis movement and helping maintain consistent suspension behavior during competitive running.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Will I need different screws to fit this tower

Most installations use the same fasteners as the stock tower, but check thread engagement and replace stripped screws to avoid stress on the graphite.

Can this part be used for wet or dusty tracks

Graphite itself handles dust and moisture well but keep bearings and pivot points clean; regular maintenance ensures reliable performance in varied conditions.

Should I change shock mounting positions when switching to graphite

Some drivers adjust mounting positions to fine tune balance after fitting a stiffer tower; small adjustments often yield noticeable handling improvements.

Is the tower compatible with aftermarket shock sets

Yes, it works with most aftermarket shocks that follow BD10 mounting standards, but always verify clearance and shaft lengths before final assembly.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved