Yokomo B12-001BS Graphite Bumper Plate 2.4mm  [B12-001BS]

Yokomo B12-001BS Graphite Bumper Support (2.4mm) for BD12/11
Price:
NZD$15.29
Brand:
Yokomo
Model:
B12-001BS
GTIN:
639342222957
Condition:
Brand New
Write a review
alt="Yokomo B12-001BS Graphite Bumper Support (2.4mm) for BD12/11" title="Yokomo B12-001BS Graphite Bumper Support (2.4mm) for BD12/11"

Reinforce the front of your Yokomo BD12/11

The Yokomo B12-001BS is a purpose-made 2.4mm graphite bumper support that helps shield the nose of BD12/11 chassis from impact damage. It bolsters the bumper area so repairs after contact can be less frequent and less involved.

Why graphite makes sense for racers

Graphite components offer toughness with minimal added weight, making them popular in competitive setups. This bumper support takes hits on the front section while preserving the car's balance and responsiveness.

Compatibility details and fitting tips

Compatible with MSR-BD11, MSR-BD12, MSR-BD12A, MSR-010, and MSR-010A, the support installs using the stock mounting locations. A quick test fit before final tightening will ensure correct alignment.
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

Can I use this on a modified chassis?

If your modifications keep the original bumper mounts, the plate will fit. Significant chassis changes may require checking hole positions before assembly.

Will it change handling or weight distribution?

At 2.4mm thickness graphite adds minimal weight, so handling changes are negligible. It mainly increases front stiffness without upsetting balance.

Is the finish prone to scratching?

Graphite surfaces can show scuffs after contact, but these do not typically affect structural integrity. Light sanding or replacement is an option if appearance matters.

Any advice for mounting screws?

Use the recommended screw sizes and avoid over-torquing. A small amount of thread locker is fine but avoid excessive torque that could crack the graphite.

Copyright © 2008-2025 rcjaz.co.nz All rights reserved