Yokomo B7-BTC Resin Belt Cams compatible with BD7/BD5/DRB 4 pcs  [B7-BTC]

Yokomo B7-BTC Belt Tension Cams for BD7/BD5/DRB
Price:
NZD$5.36
Brand:
Yokomo
Model:
B7-BTC
GTIN:
3888
Please kindly input your name and email address, we will inform you once we have the restocking.
Or you may find similar product under the
Spares / Hop-ups - Yokomo - BD7 category
Write a review

Resin belt cams tailored to BD7/BD5/DRB

The Yokomo B7-BTC kit supplies four resin tension cams purpose-built for 1/10 touring car chassis. Moulded from lightweight resin, they add minimal mass yet permit quick belt tension changes without swapping bulkier components.

Placed along the belt routing, the cams alter take-up and the tension point, helping tune belt stability and drive feel during setup. Fitting is simple for those used to belt-drive touring cars: remove the belt cover and replace the existing cams following the chassis service steps.

Tuning advice: make modest adjustments and recheck belt runout and alignment as you go. Since the parts are resin, do not overtighten nearby fasteners to avoid warping. These cams suit tuners seeking a low-weight option for fine control on the listed chassis.

Packing

  • 4 pcs belt tension cams

Compatible chassis

  • DP-DIBRS
  • DP-DIBRSB
  • MRTC-BD7RS
  • MRTC-BD715B
  • MRTC-BD715O
  • MRTC-BD715S
  • MRTC-BD716
  • MRTC-BD716H
  • MRTC-BD716O
  • MRTC-BD716S
  • MRTC-BD7RS2
  • MRTC-BD7RS3S
  • DP-DIB2
  • DP-DIB2R
  • DP-DIB2A
  • DP-DIB2RA
  • DP-DIB
  • DP-DIBR
  • DP-DIBG
  • DP-DIBL
  • DP-DIBLR
  • DP-DIBLG
Remark :
Due to limited stock availability, please notice that some Yokomo items may have to order from the factory and the ready time is around 4-6 weeks. Customer purchases the item is assumed to accept the waiting time which allows us to order directly from the manufacturer if the item is out of our warehouse.

How many cams are provided and what do they service

Four resin cams are provided in the set; these are intended to adjust belt tension and service both sides of the drivetrain on compatible models.

Will these fit as direct replacements on my chassis

They are designed to replace the existing cams on the listed platforms, but note that resin will wear differently and has lower abrasion resistance than metal.

Installation precautions I should follow

Work in small adjustment steps, verify belt alignment after each change, and do not overtighten adjacent screws to avoid damaging the resin cams.

Copyright © 2008-2026 rcjaz.co.nz All rights reserved